jaybar Senior Member Joined: 13 Sep 2011 Posts: 115 Location: Brooklyn Expertise: Just starting
Posted Sun Sep 9, 2012, 7:33am Subject: Is there a formula to figure out beverage yield for a Chemex?
Try as I may, my beverage yield always falls short.
I thought the following formula would work:
Yield=water poured- water absorbed
I want to get to twenty ounces of beverage.
I figure the water absorbed to be 2* coffee weight,
I insert the filter, add the coffee, TARE the scale and pour the water. When I lift out the filter, I am left with far less that my supposed formula would show. Do I also need to account for the dry weight of the coffee and the weight of the filter?
I want to finnish with 20 ounces of beverage in the pot I am using the eight cup handblown. I can't use the bubble marker because that is at 24 ounces in the handblown.
What formula should I use? What amount of coffee and water will result in 20 ounces in the pot?
I think you're on the right track. A more accurate (but slightly more complicated) formula might be:
Beverage Yield = (Water poured)-(Water Evaporated)-(Water Absorbed by Grounds)+(Coffee Solids Extracted into Beverage)
Hopefully water evaporated is low, and as Steve says, you probably compensate for the instantaneous evaporation by pouring over a scale. Water absorbed by grounds might be higher than 2.0x for Chemex, we could call it 2.3x. Coffee solids extracted into beverage is ideally around 19% of the dry grounds weight.
So your typical pour using ounces by weight would be: 23 oz brew water; 1.42 oz dry grounds; 2.3x the dry grounds weight water absorbed; 19% extraction.
Beverage = (23 oz Brew Water) - (0 oz Water Evaporated) - (2.3x1.42=3.3 oz water absorbed) + (.19x1.42=.27 oz coffee solids) = 23 - 3.3 + .27 = approx 20 oz
That should be approximately correct, depending (mainly) on how much water is actually absorbed and evaporated, and (to a lesser extent) on how much solids material is extracted.
Posted Sun Sep 9, 2012, 7:48pm Subject: Re: Is there a formula to figure out beverage yield for a Chemex?
Ever the empiricist, I'd sacrifice a Chemex filter, weighing it, soaking it in water, letting it drain for roughly the length of a brewing cycle, and re-weighing it to determine how much water it holds. Who needs formulas when you can have actual hard data?
Symbols: = New Posts since your last visit = No New Posts since last visit = Newest post
Forum Rules: No profanity, illegal acts or personal attacks will be tolerated in these discussion boards. No commercial posting of any nature will be tolerated; only private sales by private individuals, in the "Buy and Sell" forum. No cross posting allowed - do not post your topic to more than one forum, nor repost a topic to the same forum. Who Can Read The Forum? Anyone can read posts in these discussion boards. Who Can Post New Topics? Any registered CoffeeGeek member can post new topics. Who Can Post Replies? Any registered CoffeeGeek member can post replies. Can Photos be posted? Anyone can post photos in their new topics or replies. Who can change or delete posts? Any CoffeeGeek member can edit their own posts. Only moderators can delete posts. Probationary Period: If you are a new signup for CoffeeGeek, you cannot promote, endorse, criticise or otherwise post an unsolicited endorsement for any company, product or service in your first five postings.