Posted Thu Nov 8, 2012, 2:57pm Subject: Re: Steam LEVER upgrade for Oscar
this went even easier than i expected. I did not have to cut or permanently modify anything. Everything almost fit right in.
The toughest part was to tighten down a hex bolt because of minimal clearance which would have been remedied if i had a stubby 2.5mm hex key (like these Click Here (www.amazon.com) ).
In summary, it involves assembling the valve like the NS Aurelia part diagram shows.and directly replacing it onto where oscar's stock valve is(also want to remove the steam wand and screw it into the new valve body). You'll want to keep the lever assembly off while installing the new valve onto the machine. Once everything is on, you want to properly align and tighten down the lever.
The tough part that I mentioned is because there is very little room for a regular sized L hex key to fit while you're trying to tighten the lever to the valve. I had to loosen the front plastic panel(dont remove it because you cant get it back on if the lever is attached) to give a little extra room. I think i'll buy a stubby hex key and retighten it down as the lever is slightly loose from not being able to get my regular hex to fit in the limited space.
I've taken pics and i'll attach if anyone has any questions
plindy Senior Member Joined: 27 Nov 2002 Posts: 73 Location: Seattle Expertise: Just starting
Espresso: NS Oscar Grinder: SJ Pharos Lido HG-One
Posted Wed Nov 21, 2012, 2:10am Subject: Re: Steam LEVER upgrade for Oscar
To access the allen head adjustment screw of the steam fork, remove the top cover and then drill a small hole through the side of the front plastic. The top cover will cover the hole when reassembled.
I was unable to access the momentary or purge function the the lever arm, (push up) without removing a lot of material for the lever arm.
I had the same idea as fank828 but went about it differently. As the steam fork was able to fit the old (threaded) and new style (unthreaded). I ordered the piston, O rings, and steam fork, and lever arm, 3/8 BSPP nut. Bored out screw threads of the old valve body turned a bushing for the piston and pressed the new bushing in the old valve body. Put the nut on the valve body, adjusted the steam fork and lever, tightened the nut against the metal back plate of the front cover. That moves the steam wand back from the front edge of the underside of the top cover. Put 2 bends in the pipe from the boiler to the valve body so there was no strain on the front cover.
Yet to complete, trying to fit different lever assembly. The idea is to use the original steam knob as a cover...
Symbols: = New Posts since your last visit = No New Posts since last visit = Newest post
Forum Rules: No profanity, illegal acts or personal attacks will be tolerated in these discussion boards. No commercial posting of any nature will be tolerated; only private sales by private individuals, in the "Buy and Sell" forum. No SEO style postings will be tolerated. SEO related posts will result in immediate ban from CoffeeGeek. No cross posting allowed - do not post your topic to more than one forum, nor repost a topic to the same forum. Who Can Read The Forum? Anyone can read posts in these discussion boards. Who Can Post New Topics? Any registered CoffeeGeek member can post new topics. Who Can Post Replies? Any registered CoffeeGeek member can post replies. Can Photos be posted? Anyone can post photos in their new topics or replies. Who can change or delete posts? Any CoffeeGeek member can edit their own posts. Only moderators can delete posts. Probationary Period: If you are a new signup for CoffeeGeek, you cannot promote, endorse, criticise or otherwise post an unsolicited endorsement for any company, product or service in your first five postings.