Posted Sun Sep 16, 2012, 8:52pm Subject: Re: PID vs Surfing
I am a little late to this party, but as I have said before:
-Just 'using' Silvia is like standing on the tracks, blindfold in place, waiting for the train.
-Time surfing (light on, wait 45 seconds, pull shot) is like standing on the tracks, running a stopwatch, and stepping off the tracks to see if the train is there, and hoping you got the timing correct.
-Temp surfing with the digital readout was like trying to jump on a train as it ran through the station at speed.
-PID is a leisurely boarding onto a stopped train with champagne served at the door by a very gracious porter..
So, staying with the transportation simile using a DB or HX machine is like getting a first class seat on a private jet.
Anyway, sorry for taking a while to get back, I was offline since Thursday afternoon.
Using the PID makes that machine much easier to use. The pre infusion I was referring to was one of my own design and I have not found the need to add it. In truth, I do not use that machine much, as I have removed it from work and it follows me on vacation only anymore.
The PID kit is very easy and either mounting under between the GH and the steam wand or cutting a hole in the case is easy to do, cutting the hole is a bit more involved though and the under mount option allows for removal of the kit with no alteration of the machine. I don't know why you would want to remove it, even for sale but there you go, it is an option anyway.
In real life, my name is Wayne P.
Feed the newbs, starve the trolls and above all enjoy what you drink!
The train is in the station but I'm still on the ramp. I went from holy cow I could never cut my case to, I envy those that did it is so nice looking. The plot thickens. I found a machinist to cut my case since I don't have the tools or skills. I have an email into Suyi asking about temp limits on the unit. I want to make sure it can hold up inside. I read a story about it's fine inside then when the steam is heating up it shuts off, but don't worry as it cools it works again.
The temperature will be some lower if you insulate, or, you could insulate the PID. If the PID is in the upper R facing, then you have a box front, top, and L side made by the machine. Use rigid insulation to make the lower, R and rear walls. To really cool the PID, you may then need to vent the R case side and top for air flow. A couple of holes by the machnist could look fine, vent, and cool.
Or install the PID sitting on top and then think about location. You can always cut the hole later.
Symbols: = New Posts since your last visit = No New Posts since last visit = Newest post
Forum Rules: No profanity, illegal acts or personal attacks will be tolerated in these discussion boards. No commercial posting of any nature will be tolerated; only private sales by private individuals, in the "Buy and Sell" forum. No cross posting allowed - do not post your topic to more than one forum, nor repost a topic to the same forum. Who Can Read The Forum? Anyone can read posts in these discussion boards. Who Can Post New Topics? Any registered CoffeeGeek member can post new topics. Who Can Post Replies? Any registered CoffeeGeek member can post replies. Can Photos be posted? Anyone can post photos in their new topics or replies. Who can change or delete posts? Any CoffeeGeek member can edit their own posts. Only moderators can delete posts. Probationary Period: If you are a new signup for CoffeeGeek, you cannot promote, endorse, criticise or otherwise post an unsolicited endorsement for any company, product or service in your first five postings.