Good initial grind.

Severe durability problems.  Unit lasted only 1 year and 9 months.

Short story: you'll like this grinder until it breaks.  Which, corroborated by other reviews posted here over the last year or so, is when you one day go to clean it and instead end up breaking it completely.

Long story: there are these two plastic nubs that stick up from the plastic base that are part of the mechanics that hold the feed/hopper in place.  Eventually what happens is that the unit leaks all over the inside of itself.  You can perhaps avoid this by cleaning it very regularly, where regularly is defined as more often than every six months, which is about what I did.  Once it has leaked though, the hopper ring adjustment mechanism becomes jammed.  And you'll very likely end up breaking off one of the two nubs if you forcibly twist the hopper to put it into its release position.  It's game over once you break a nub; the unit has to go back for servicing.  But wait, there's more.  Even after I got the hopper off, but before I realized that I'd broken the nub, I tried to remove the plastic ring that holds the burr cylinder to clean it.  Nope.  Won't come out this time.  Now I've had it out before so I know how it works.  But this time, it's slightly twisted off center and it won't align properly to lift out anymore.  Eventually you'll break it getting it out.  And once it's out, you'll notice that your burr is dead on top of it all.  It's a weird feeling watching a piece of equipment near and dear to your heart essentially committing suicide before your own eyes.

Hint: if you have one of these and your hopper won't twist - DON'T FORCE IT.  Try shaking the machine and turning it upside down and shaking it.  If you force the hopper you will probably break the nub.  I have no hint as to what to do to get the burr cylinder out.  I couldn't figure out what was wrong with it even after it was out and broken off.  Best guess is that the leaked grinds are an effective door wedge, as it were.

In researching this problem, I found identical reports from lots of other folks.  It's apparently a pretty common failure mode.  So common in fact that the currently shipping version apparently has stronger nubs.  I've also read a few reports of people who managed to get Solis to replace their broken units for free.  However now knowing that the lifetime of the burr is less than two years (and ~$30 on its own), I didn't pursue getting it fixed.  It's time to upgrade for me.

Bottom line: if you're spending $150 on a coffee grinder, I'd recommend spending another $100 to get something that's properly engineered.  Sadly I must conclude that the Maestro Plus is overpriced and poorly engineered.

No problems, quick shipment.  I would use them again.